Where WatchGuard Goes to Work
One family of coatings covering the building from the deck of the roof to the slab of the floor.
Request a Line CardOne Shield, Every Surface
Most coating brands are built around a single chemistry and then stretched over every job that walks in the door. WatchGuard was assembled the other way around. Each line in the family exists because a crew somewhere needed a product that did not exist yet: a roof coating that could survive a Wisconsin freeze-thaw cycle, a floor kit that returned a shop to service in one day, a concrete mender that let forklifts roll an hour after the pour. The result is a family of six lines that share a standard, not a shortcut.
That standard shows up in the details contractors care about. Every WatchGuard product ships with a current technical data sheet and safety data sheet. Every line has a recommended primer path, so you are never guessing at adhesion over TPO, EPDM, rusted metal or dusty concrete. And every system is designed to be sprayed, rolled or squeegeed with equipment a working contractor already owns.
Up Top: Roofs and Exterior Envelopes
On the roof, WatchGuard means seamless restoration instead of tear-off. Polyurea basecoats bring tensile strength measured in thousands of PSI to metal and spray foam decks, while silicone topcoats shrug off ponding water and reflect summer heat. Combined with WatchGuard Primer as a universal tie-coat, the roof line adheres to TPO, EPDM, modified bitumen, galvanized steel and aged coatings without a chemistry experiment on the job site.
Typical projects include low-slope commercial roofs, agricultural buildings, metal warehouses and spray-foam-over-deck retrofits where the coating is the weather barrier.
Down Below: Floors and Concrete
At grade level the family switches from flexible membranes to wear surfaces. WatchGuard Floor kits put a 100 percent solids polyurea wear layer over garages, shops and warehouse aisles, with color chip and topcoat options when appearance matters. WatchGuard Concrete adds fast-set crack menders and joint fill for slabs that cannot wait: gel times measured in seconds, traffic in about an hour.
Between the two, a facility can repair spalled joints, rebuild a wear surface and stripe a traffic lane inside a single weekend shutdown.
Inside the Walls
WatchGuard Foam and WatchGuard Spray Foam round out the family inside the envelope. Open and closed cell spray foam systems deliver R-6.5 to R-7 per inch of closed cell insulation with dependable yield, and the spray foam program backs contractors with supply scheduling, rig support and applicator training. For insulation contractors, that means one supplier who understands both the chemical set in the tote and the proportioner in the trailer.
Wherever your work falls in the building, there is a WatchGuard line already proven on it. Tell us what you are coating and we will send the line card, the data sheets and honest guidance on which system fits.
Get the Full Line Card
One PDF, six lines, every spec. Tell us what you build and we will include pricing for the systems that fit.
Request a Line CardRequest a Line Card
Tell us about your project and we will follow up with product details, technical data sheets, and pricing.